http://www.floodsafety.com/national/property/cleanup/Ceilings and walls-
Wallboard acts
a sponge when wet. Remove wallboard, plaster and paneling to at least the flood level. If soaked by contaminated floodwater, it can be a permanent health hazard and should be removed. If most of the wallboard was soaked by clean rainwater, consider cutting a 4- to 12-inch-high section from the bottom and top of walls. This creates a "chimney effect" of air movement for faster drying. A reciprocating saw with a metal cutting blade works well, but use only the tip of the blade and watch out for pipes, ductwork and wiring.
Plaster and paneling can often be saved, but air must be circulated in the wall cavities to dry the studs and sills.
The three kinds of insulation must be treated differently. Styrofoam might only need to be hosed off. Fiberglass batts should be thrown out if muddy but may be reused if dried thoroughly. Loose or blown-in cellulose should be replaced since it holds water for a long time and can lose its antifungal and fire retardant abilities.
Floors-
With wood subflooring, the floor covering (vinyl, linoleum, carpet) must be removed so the subflooring can dry thoroughly which may take several months. Open windows and doors to expose the boards to as much air as possible.
Carpeting-
Clean and dry carpets and rugs as quickly as possible. If sewage-contaminated floodwater covered your carpeting, discard it for health safety reasons. Also discard if the carpet was under water for 24 hours or more. To clean, drape carpets and rugs outdoors and hose them down. Work a disinfecting carpet cleaner into soiled spots with a broom. To discourage mildew and odors, rinse with a solution of 2 tablespoons bleach to 1 gallon water, but don't use this solution on wool or nylon carpets. Dry the carpet and floor thoroughly before replacing the carpet. Padding is nearly impossible to clean so should be replaced. If the carpet can't be removed, dry it as quickly as possible using a wet/dry vacuum and dehumidifier. Use a fan to circulate air above the carpet, and if possible, lift the carpet and ventilate with fans underneath.
Vinyl flooring and floor tile may need to be removed to allow drying of subfloor.
Wood floors-
Wooden floors should be dried gradually. Sudden drying could cause cracking or splitting. Some restoration companies can accelerate drying time by forcing air through the fluted underside of hardwood floorboards. Remove hardwood floor boards to prevent buckling. Remove a board every few feet to reduce buckling caused by swelling. Clean and dry wood before attempting repairs.
น่าจะมีคนเอาระบบนี้เข้ามาหรือทำเลียนแบบ น่าจะได้ลูกค้าตรึม
http://www.tesdryingsystem.com/videos/tes_intro.html
