HTG2.club
Home Theater Guide webboard => มุม โฮมเธียเตอร์ (HT) => ข้อความที่เริ่มโดย: vut15 ที่ 02 พฤศจิกายน, 2009, 10:12:53 pm
-
ขอความรู้เรื่องรีโมทตัว DENON 2808 สามารถเซตให้ใช้กับ CD marantz 63se ได้หรือเปล่าคับและต้องทำอย่างไรบ้างขอความรู้ด้วยคับท่านอาจารณ์ทั้งหลาย
ขอบคุณคับ
-
ในคู่มือหน้า 54 มีบอกวิธี Learning Function ครับ
http://www.usa.denon.com/AVR-2808CI-OM-E_102.pdf
ซึ่งน่าจะสามารถ learn สัญญาณของ remote ตัวอื่นๆได้
Learning Function
If your AV devices are of a brand other than DENON or if they
cannot be operated with the preset memory function, their
remote control signals can be transfered to stored in the AVR-
2808CI’s main remote control unit.
1 Press [MODE SELECTOR] for the device you want to
set.
2 Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3 Press [9], [7] and [5], in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
4 Press the button to be set.
The main remote control unit’s display turns off.
b If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
5 Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
b If you want to learn other buttons, repeat steps 4 and 5.
b The mode can be switched by pressing [MODE SELECTOR].
b The signal transmission indicator lights once for a long time if
learning was not possible
6 Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device’s own remote control unit.
• Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
56).
NOTE
• [HOME] cannot be learned.
• Do not learn any remote control signals at [RC SETUP].
• The AMP, ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes cannot
be learned.